Synthetic Floor Protectant – E13


pdf_iconlargeEnglish Spec / Data Sheet
pdf_iconlargeEnglish SDS Sheet
pdf_iconlargeIngredient Disclosure

106118: 1 x 2.5 Gallon – Stackable
106119: 2 x 2.5 Gallon
106110: 5 Gallon
106123: 55 Gallon drum
Categories: , , SKU: e13


elements Synthetic Floor Protectant

A new generation of an environmentally preferable synthetic floor finish designed to work on any type of synthetic floor due to its exceptional durability and flexibility. This synthetic floor finish is specifically formulated to work on rubberized flooring due to its elastic properties that will prevent cracking. Meets today’s need for a product that contains no zinc or other heavy metals that can be harmful to wastewater treatment systems. This low odor finish has the flexibility needed to protect a synthetic floor, while being tough enough to stand up to excessive wear on that occurs on synthetic sport floors.

PREPARATION: For new synthetic floors, make sure to check with the manufacturer regarding the warranty and specific maintenance recommendations before beginning. For older floors that are out of warranty, simply follow these steps to clean and prepare the floor for coating. If floor is in good condition and stripping is not necessary, sweep up excess dirt and dust and then clean with a good neutral cleaner following the directions accordingly to remove dirt and oils. If there is a heavy build-up of acrylic, urethane, or other film coatings, use a neutral stripper and follow directions accordingly. Follow with a thorough rinsing and allow floor to dry completely.

FINISHING: Apply 2 to 3 thin coats of product using a micro-fiber applicator or clean finish mop. Allow a minimum of 30 minutes drying time between coats. Repeat until a desired level of gloss is achieved.

RESTORATION: Dust mop or sweep thoroughly. Use a gloss restorer according to directions and apply to floor with clean mop or auto-scrubber.

RECOATING: Dust mop or sweep thoroughly. Deep scrub using a general purpose cleaner diluted according to directions. Apply 1 or 2 coats of finish using a clean mop.


Color White
Odor Fragrance free
pH 8.0 – 8.5
Non-Volatile Solids 18%
Coverage 1800 – 2200 ft2 / gal.
Recommended Coats 2 – 3
Dry / Recoat Time 45 minutes min.
Maintenance Schedule Daily cleaning
Slip Resistance 0.5 min. by ASTM-D2047
Storage/Stability 2 years
Weight per Gallon 8.54 lbs./gal.
Freeze/Thaw Stability Keep from freezing

Additional information


Recommended Coats

Maintenance Schedule